104
To prepare the Remote Commander
Insert two size AA (R6) batteries by matching the + and – on the batteries to the
diagram inside the battery compartment.
Note on battery life
The batteries for the Remote Commander last about 6 months under normal operation.
When the batteries become weak or dead, the Remote Commander does not work.
To avoid damage from possible battery leakage
Remove the batteries when you will not use the Remote Commander for a long time.
To watch the demonstration
You can start the demonstration by setting DEMO MODE in the menu system.
You can also start the demonstration by the following operation.
When NIGHTSHOT is set to ON, you cannot watch the demonstration.
To enter demo mode
(1) Eject the cassette and set the POWER switch to VTR.
(2) Turn STANDBY up to STANDBY.
(3) While holding down ( set the POWER switch to CAMERA.
To exit demo mode
(1) Set the POWER switch to VTR.
(2) Turn STANDBY up to STANDBY.
(3) While holding down p set the POWER switch to CAMERA.
Identifying the parts
RMT-717 RMT-708
To Next Page
Loading...
Need help?
General