masterpage:Left
filename[I:\#Sagyou\#04\0422\4291560111\4291560111CECH3001AUC\01US\01EN
02XXX.fm]
6
EN
model name1[CECH-3001A/CECH-3001B]
[4-291-560-11(1)]
occurs as a result of moving the system may cause data loss or
corruption, or damage to the system.
• Do not stand on or put objects on the system, and do not stack the
system with other devices.
• Do not place the system and connected accessories on the floor
or in a place where they may cause someone to trip or stumble.
• Do not allow bodily contact with the system or air from the system
vents for an extended period of time while in use. Extended
contact under these conditions may cause low-temperature
burns.
• When connecting the system to a plasma or projection
*
TV, do not
leave a still image on the TV screen for an extended period of time,
as this may leave a faint image permanently on the screen.
* Except LCD screen types
• Parents are encouraged to monitor children in online activities to
ensure safe and responsible Internet usage.
About the USB device
If "An unknown USB device has been connected" is displayed on-
screen, the reason may be one of the following:
• The connected USB device is not compatible with the system.
• The connected USB device is compatible with only some software
titles.
• Too many USB devices are connected to the USB hub.
Notes on safety when using the DUALSHOCK®3
Wireless Controller*
• Stop using the system immediately if you begin to feel tired or if
you experience discomfort or pain in your hands or arms while
operating the DUALSHOCK®3 Wireless Controller. If the condition
persists, consult a doctor.
• The vibration function of the DUALSHOCK®3 Wireless Controller
can aggravate injuries. Do not use the vibration function if you
have any ailment or injury to the bones, joints or muscles of your
hands or arms. If you have an ailment or an injury, do not play
software titles that contain the vibration function using the
DUALSHOCK®3 Wireless Controller unless you have set the
vibration function to [Off].
• Avoid prolonged use of the DUALSHOCK®3 Wireless Controller.
Take a break at about 30-minute intervals.
• Note that some software titles set the vibration function to [On] by
default. To disable the vibration function, press the PS button of
the controller, and then select [Controller Settings] [Vibration
Function] [Off]
• When using the motion sensor function of the wireless controller,
be cautious of the following points. If the controller hits a person
or object, this may cause accidental injury or damage.
– Before using, check that there is plenty of space around you.
– When using the controller, grip it firmly to make sure it cannot
slip out of your hand.
– If using a controller that is connected to the PS3
™
system with a
USB cable, make sure there is enough space for the cable so
that the cable will not hit a person or object. Also, take care to
avoid pulling the cable out of the PS3
™
system while using the
controller.
– Some PlayStation® and PlayStation®2 peripherals such as the
analog controller (DUALSHOCK®) and analog controller
(DUALSHOCK®2) are not compatible with the PS3™ system.
For details, visit www.us.playstation.com.
* These notes may also apply to other controllers.
Vents
Do not block any vents. To maintain good ventilation, follow the
guidelines below:
• Place the system at least 10 cm (4 in) away from a wall surface.
• Do not place on a carpet or rug with long fibers.
• Do not place in a narrow or cramped space.
01PSP-1001 EN.book Page 6 Friday, April 22, 2011 6:45 PM
To Next Page
Loading...
Need help?
General
