Help Guide
Shotgun Microphone
ECM-B10
Notes on use
To protect the connector of the Multi Interface foot from damage while carrying around this unit, remove the unit from
the camera, attach the connector protect cap to the foot and put the unit in the supplied pouch.
While recording is in progress, operation and handling noises of a camera or a lens may be recorded. Touching this
unit while recording is in progress causes a noise to be included in the recording.
Monitoring or recording voice with the microphone of a camera may cause a slight delay of the voice.
Before changing the lens, make sure that no wind screen fibers are present on the surface of the lens and the
camera body. If present, clean them off with a blower etc. and then change the lens.
If dust or water droplets are present on the surface of the microphone, a successful recording may not be possible.
Be sure to clean the microphone surface before using this unit.
5-036-505-11(1)
Copyright 2021 Sony Corporation
To Next Page
Loading...
Need help?
General
