Sony HCD-SBT300W User Manual

HCD-SBT100/SBT100B/SBT300W/SBT300WB
17
2-13. CHASSIS (MAIN) BLOCK-2
9 flexible flat cable (24P)
(CN501)
7 chuck cap
6 claw
6 claw
6 claw
0 chassis (main) block
OK
NG
2 screw
(BV3)
3 coating clip
3 coating
clip
2 two screw
(BV3)
2 screw
(BV3)
2 screw
(BV3)
2 two screws
(BV3)
4 Remove the
chassis (main) block
in the direction
of an arrow.
5 Remove the chuck cap
in the direction
of an arrow.
1 Draw out
wires.
(SBT300W/
SBT300WB)
– Rear view –
Note 1: Before disconnecting flexible flat cable (24P) (CN501), solder the short-land.
Note 3:
When installing the flexible flat cable,
ensure the colored line.
No slanting after insertion.
Note 4:
When installing
the chuck cap,
align the triangle
marks.
colored line
colored line
Inserting is straight to the interior.
Inserting is slant.
flexible flat cable
flexible flat cable
connector
connector
OK
NG
OK
NG
8
Solder the short-land.
Note 2: When assembling the
chassis (main) block,
remove the solder of
short-land after connecting
flexible flat cable (24P)
(CN501).
Solder is removed cleanly.
Solder is not removed.

Sony HCD-SBT300W Specifications

General

Brand	Sony
Model	HCD-SBT300W
Category	Car Receiver
Language	English