9
Getting Started
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack H series (p. 78) after
attaching it to your camcorder.
b Notes
• You cannot attach any “InfoLITHIUM” battery
pack other than H series to your camcorder.
1 Open the jack cover, then align
the v mark of the DC plug with
the V of the DC IN jack on the
camcorder, then connect the DC
plug to the DC IN jack on the
camcorder.
2 Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
3 Slide the POWER switch to OFF
(the default setting).
4 Attach the battery pack by sliding
it in the direction of the arrow
until it clicks.
The CHG (charge) lamp lights up and
charging starts. When the CHG (charge)
lamp turns off, the battery pack is fully
charged.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
DC IN jack
DC plug
AC Adaptor
Power cord
(Mains lead)
To the wall outlet
(wall socket)
CHG (charge)
lamp
Jack cover
Battery pack
POWER switch
To Next Page
Loading...
Need help?
General