2
Be
sure to install this unit in the
dashboard
of
the car for safety.
For installation and connections,
see the supplied installation/ connections
manual.
FOR
UNITED
STATES
CUSTOMERS.
NOT
APPLICABLE
IN
CANADA,
INCLUDING
IN
THE
PROVINCE
OF
QUEBEC.
POUR
LES
CONSOMMATEURS
AUX
ETATS-UNIS.
NON
APPLICABLE
AU
CANADA,
Y
COMPRIS
LA
PROVINCE
DE
QUEBEC.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part
15
of
the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if
not
installed
and
used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there
is
no guarantee that
interference will
not
occur in a particular
installation.
If
this equipment does cause
harmful interference to radio
or
television
reception, which can be determined by
turning the equipment off and on, the user
is
encouraged to
try
to correct the
interference by one
or
more
of
the
following measures:
- Reorient
or
relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on
a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
You
are cautioned that any changes
or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
This device complies with
Part
15
of
the
FCC Rules and Industry Canada
licence-exempt
RSS
standard(s).
Operation
is
subject to the following two
conditions: (
1)
this device may
not
cause
harmful interference, and
(2)
this device
must accept any interference received,
including interference that may cause
undesired operation
of
the device.
This transmitter must
not
be co-located
or
operated in conjunction with any other
antenna
or
transmitter.
Under Industry Canada regulations, this
radio transmitter may only operate using an
antenna
of
a type and maximum (or lesser)
gain approved for the transmitter by
Industry Canada. To reduce potential radio
interference to other users, the
antenna
type
and its gain should be so chosen
that
the
equivalent isotropically radiated power
(e.i.r.p.)
is
not more
than
that necessary for
successful communication.
This equipment complies with FCC/IC
radiation exposure limits set forth for an
uncontrolled environment and meets the
FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65
and
RSS-102
of
the IC radio frequency (RF)
Exposure rules. This equipment has very
low levels
of
RF
energy that it deemed to
comply without maximum permissive
exposure evaluation
(MPE).
But it
is
desirable that it should be installed and
operated keeping the radiator at least
20
em or more away from person's
body
(excluding extremities: hands, wrists, feet
and
ankles).
CAUTION
The use
of
optical instruments with this
product will increase eye hazard.
To Next Page
Loading...
Need help?
General
