If
the device supports Bluetooth version
2.1, passkey input
is
not
required.
*Passkey may be called "passcode," "PIN
code," "PIN number" or "Password," etc.,
depending
on
the device.
,.
""'
-II--
xxxx
-1
-
~
~
~
Input passkey
"0000"
This unit and the Bluetooth device
memorize each other's information,
and
when pairing
is
made, 0 stays lit.
The unit
is
ready for connection to the
device.
I~M§i
If"
0"
continues to flash, the Bluetooth
device may not be compatible with this unit.
For details on compatible devices, visit the
support site
on
the back cover.
5 Select this
unit
on
the Bluetooth device
to be connected.
''
~""
or ''
~""
appears when the
connection
is
made.
I~Mi#J
• While connecting to a Bluetooth device, this
unit cannot be detected from another device.
To enable detection, enter the pairing mode and
search for this unit from another device.
•
It
may take time to search or connect.
• Depending
on
the device, the confirmation
display
of
the connection appears before
inputting the passkey.
• The time limit for inputting
the
passkey differs
depending on the device.
If
the time expires,
perform the pairing procedure from the
beginning again.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
Connection between this unit
and
the Bluetooth
device may be automatic, depending on the
device.
Cancelling
pairing
Perform step 2 to cancel the pairing mode
after this unit and the Bluetooth device are
paired.
To use the device after pairing is made, start
the connection. Sometimes pairing allows
for connection automatically.
If
pairing has already been achieved, start
operation from here.
Connecting a
cellular
phone
1 Press (
CALL)
and
rotate
the
control
dial until "SET BT SIGNL" appears,
then
press it.
''0"
lights up when Bluetooth signal
is
activated.
I~M§i
When the Bluetooth signal for this unit
is
already ON, selecting "SET
BT
SIGNL"
deactivates the Bluetooth signal.
You can also output the Bluetooth signal from
this unit by pressing and holding (
CALL)
on
this unit more than two seconds.
23