13
GB
1 Turn the Jog dial to select
the component you want to
operate.
At the factory, the selection
order is preset as follows.
Notes
• If you have changed the name of
the component (page 26) that
name is displayed.
• You can change the selection
order also (page 24).
2 Press the button for the
desired function.
See “Table of Preset Functions”
(page 38) for the functions of
buttons for each component.
When a remote control signal is
sent, appears in the display.
Tip
You can skip an unused component
from the selection menu by entering
“000” to the code number (page 10). To
put it back on the display, set the code
number to match your component.
Note
The remote control signals may be
different for some components or
functions. In this case, program the
remote control signals with the
Learning function (see page 15).
Operating Your
Components with the
Remote Commander
When you operate a non-Sony
component, make sure you set the
component code number first
(page 8).
Operating a component
Continued
TV SAT VCR DVD
CD
AMP TAPE MD
VT
Jog
dial
To Next Page
Loading...
Need help?
General
