SERVICE MANUAL
Sony Corporation
Audio Group
Published by Sony Engineering Corporation
US Model
Canadian Model
SA-WMSP87
AEP Model
UK Model
SA-WMSP87E
E Model
Australian Model
SA-WMSP87
ACTIVE SUBWOOFER
9-879-452-02
2005J16-1
© 2005.10
Ver. 1.1 2005.10
SPECIFICATIONS
SA-WMSP87/WMSP87E
• SA-WMSP87/WMSP87E are the
sub woofer section in HT-5950DP/
DDW675 and HT-DDW870.
Photo: SA-WMSP87
M•
•
odels of area code CEL, CEK
(SA-WMSP87E)
Models of other area code (SA-WMSP87)
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 6 ohm loads, from 28 – 200 Hz; rated 100
watts, minimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
Speaker system Active subwoofer,
magnetically shielded
Speaker unit 200 mm (7 7/8 inches)
cone type
Enclosure type Acoustically loaded bass
reflex
RMS output
Models of area code U, CA
155 W (5 ohms, 100 Hz,
THD 10%)
Models of area code CEL, CEK
120 W (6 ohms, 100 Hz,
THD 10%)
Models of other area code 110 W (6 ohms, 100 Hz,
THD 10%)
Input LINE IN (input pin jacks)
Power requirements
Power consumption 100 W
Dimensions (w/h/d) (Approx.)
270 × 325 × 398 mm
(10 5/8 × 12 3/4 × 15 5/ × 8
inches)
Mass (Approx.) 9.0 kg (19 lb 14 oz)
Area code Power requirements
U, CA 120 V AC, 60 Hz
MX 127 V AC, 60 Hz
CEL, CEK 230 V AC, 50/60 Hz
AU 240 V AC, 50 Hz
SP 220 – 230 V AC,
50/60 Hz
E51 120/220/240 V AC,
50/60 Hz
•Abbreviation
AU : Australian model
CA : Canadian model
CEK : UK model
CEL : AEP model
E51 : Chilean and Peruvian model
MX : Mexican model
SP : Singapore model
U:US model
To Next Page
Need help?
General
