masterpage:Left
lename[E:\SEM_Janet\Data_DB895D\J9050665_2598514111DB895DCEL\2598514111\GB07
TH_STR-DB895D-CEL.fm]
48
GB
model name1[STR-DB895D]
[2-598-514-11(1)]
This function is useful when you use 2 Sony
receivers in the same room. Use the buttons on
the receiver for the operation.
1 Turn off the receiver.
2 Hold down INPUT MODE and press ?/1
to turn on the receiver.
“C.MODE.AVX” appears in the display.
Each time you repeat the procedure above,
the display changes as follows:
C.MODE.AV1 y C.MODE.AV2
Tip
The initial setting is “C.MODE.AV2”.
Notes
• The initial setting for the command mode of the
supplied remote is “AV2”.
• If the command mode of the receiver and the remote
is different, you cannot use the remote to operate the
receiver.
You can set the receiver to turn off automatically
at a specified time. Use the remote for the
operation.
1 Press ALT to light up the button.
2 Press SLEEP repeatedly while the
power is on.
Each time you press SLEEP, the display
changes cyclically as follows:
2-00-00 t 1-30-00 t 1-00-00 t
0-30-00 t OFF
While using Sleep Timer, “SLEEP” lights up in
the display.
Tip
To check the remaining time before the receiver turns
off, press ALT to light up the button (page 52), then
press SLEEP. The remaining time appears in the
display. If you press SLEEP again, the sleep timer will
be canceled.
Changing the command
mode of the receiver
Using the Sleep Timer
GB01COV_STR-DB895D-CEL.book Page 48 Wednesday, June 15, 2005 9:28 AM
To Next Page
Loading...
Need help?
General