MULTI CHANNEL AV RECEIVER
STR-DH750/STR-DH550
PROTECTOR
The receiver will automatically turn off after a few seconds. Check the followings:
There may be an electrical surge or power failure. Unplug the AC power cord (mains lead) and then plug in
the cord again after 30 minutes.
The receiver is covered and the ventilation holes are blocked. Remove the object covering the ventilation
holes of the receiver.
The impedance of the connected speakers is below the rated impedance range indicated on the back panel
of the receiver. Reduce the volume level.
Unplug the AC power cord (mains lead) and let the receiver cool down for 30 minutes while performing the
following troubleshooting:
Disconnect all of the speakers and subwoofer.
Check that the speaker wires are tightly twisted on both ends.
Connect the front speaker first, increase the volume level and operate the receiver for at least 30 minutes until it
completely warms up. Then, connect each additional speaker one by one and test each additional speaker until
you detect which speaker is causing the protection error.
After checking the above items and fixing any problems, plug in the AC power cord (mains lead) and turn on
the receiver. If the problem persists, consult your nearest Sony dealer.
Notes on use
4-488-933-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
Loading...
Need help?
General
Weight and Dimensions
