Help Guide
Wireless Stereo Headset
WH-CH500
Making a call
You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free
Profile) or HSP (Headset Profile), via a Bluetooth connection.
If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
Operations may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied
with your smartphone or mobile phone.
This headset supports normal incoming calls only. Calling apps for smartphones and computers are not supported.
Hint
Volume for a call can be adjusted during a telephone conversation only.
Volume during a call and volume during music playback can be adjusted independently. Changing the call volume does not
change the volume of music playback, and vice versa.
Note
Use a smartphone or mobile phone at least 50 cm away from the headset. Noise may result if the headset and the smartphone or
mobile phone are too close.
Connect the headset to a smartphone or mobile phone beforehand.
1
Operate your smartphone or mobile phone to make a call.
When you make a call, the dial tone is heard from the headset.
If you make a call while you are listening to music, playback pauses.
If no dial tone is heard via the headset, switch the call device to the headset using your smartphone or mobile
phone or by holding the
button down for about 2 seconds.
A: Microphones
2
Press the + or - button to adjust the volume.
When the volume reaches the maximum or minimum, an alarm sounds.
3
To end the call, press the
button on the headset again.
If you made a call during music playback, music playback resumes automatically after ending the call.
4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
