27
Instruction Manual
Getting Started
A. FCC Notice (USA) (Cont.)
• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver,
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, or
• Consult the dealer or an experienced radio/TV technician for help.
B. Industry Canada Notice (Canada)
This Class B digital apparatus complies with Canadian ICES-003.
The term “IC” before the certification/registration number only signifies that the Industry Canada technical specifications were
met. Le terme “IC” devant le numéro de certification /d’enregistrement signifie seulement que les spécifications techniques
Industrie Canada ont été respectées. This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interfer-
ence, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son utilisation est soumise à Les deux
conditions suivantes: (1) cet appareil ne peut pas provoquer d’interférences et (2) cet appareil doit accepter Toute interférence, y
compris les interferences qui peuvent causer un mauvais fonctionnement du dispositif.
2.8 Charger Procedure
1. Plug the charger into an appropriate outlet before inserting the battery pack.
2. Insert the battery pack into the charger, as shown, making sure the pack is fully seated in the charger. The red (charging)
light will blink continuously indicating that the charging process has started.
3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may
be used at this time or left in the charger.
To Next Page
Loading...
Need help?
General
