15
Do not mount the detector behind of metal surfaces, windshield antenna, wiper
blades, ornaments mirrored sunscreen.
Window tinting reduces the received strength of laser signals, do not mount the
detector behind tinted glass.
Do not mount the detector where the driver or passenger might hit in a sudden
stop or accident.
B. Mounting Type
STAR 2041 can be installed by two type of mounting methods.
4. Hook-and Loop Mounting
The hook-and-loop tape included with your detector might be the best mounting
method for some dashboards.
Follow these instructions to use the hook-and-loop tape.
Use a damp cloth to thoroughly clean both the bottom of the detector and the
dashboard.
Peel off the tape's paper backing and apply the tape to the bottom of the
detector.
Remove the paper backing from the other side of the tape and press the detector
onto the dashboard.
2. Windshield Mounting
The supplied windshield bracket and suction cups let you quickly mount the
detector to your vehicle's windshield.
Follow these steps to use mounting bracket kit.
1. Install the suction cups onto the bracket by
fitting them into their holes.
2. Attach the bracket to windshield
3. Attach the Detector to bracket.
4. Bend bracket for correct detection angle (if
need), do not use the STAR 2041 to bend
bracket.
5. Plug power cord into detector.
6. Plug power cord into cigarette lighter.
Cautions: On some newer model cars, a plastic safety coating has been applied
to the windshield. The suction cups may leave permanent marks on the
windshield once they are removed. Check vehicle owner's manual to see if your
car has the plastic safety coating.
To Next Page
Loading...
Need help?
General
