16
C. Connecting the Power
The detector is designed to operate on most DC12V negative ground vehicle
electrical systems. The power cord provided with the detector has a cigarette
lighter socket plug at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the detector.
2. Insert the other end into the cigarette lighter socket of your vehicle.
If the detector does not operate when you turn it on, remove the adapter from
the cigarette lighter socket and carefully check the socket for debris. Also, check
the fuse in the adapter and your vehicle's fuse box.
D. Replacing the Fuse
If the detector stop operating, the fuse in the cigarette lighter plug might be
blown. If it has blown, follow these steps to replace it with 3-ampare fuse.
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has blown, if it has, replace it.
3. OPERATION
A. Power and Self-test
To turn the detector on, connect power and turn the On/Off volume control
away from you until it clicks.
When powered up, the detector sounds a distinctive tone for each signal and
flashes all LEDs in sequence as a self-test.
Then all LEDs turn off except the power LED.
B. Tutorial Mode
STAR 2041 has a tutorial mode, With the STAR 2041 off, press and hold the
“Mute” button and turn the STAR 2041 on. The STAR 2041 will enter the tutorial
mode. At this time the City LED will blink continuously. Whenever you press the
“Mute” button, the STAR 2041 will show the LED operation and sound for each
band by turns. To exit the tutorial mode, press “City” after finishing the one
operation of a band.
To Next Page
Loading...
Need help?
General
