EN
133
OPERATION
Note:
In the case of repeated use of the pump with the rope, the condition of the rope
must be checked regularly as it may decay and break over time.
Installation and commissioning
Attach a suciently long, strong rope to the carrying handle before rst use. The pump is
submerged into the liquid on this rope and can also be carried with it as well as with the
carrying handle.
Connecting the pressure pipe
For occasional use, use a suitable water hose.
The use of rigid pipes with a non-return valve is recommended for use at a xed location. This
prevents return ow of the liquid when switching o.
• Screw pressure line onto the pressure connection.
All threaded connections must be sealed with thread sealing tape (e. g. Teon® tape).
• When using a hose, screw a suitable hose adapter onto the pressure connection.
• Push the hose rmly onto the hose adapter and secure with a hose clamp.
Installation
The appliance needs an area of at least 50 × 50 cm (the oat switch must be able to move
freely so that it works properly).
The appliance can be submerged under water up to the submerged operating depth
mentioned in the technical data section of this manual.
Install the appliance so that the suction openings cannot be blocked by foreign bodies (place
the appliance on a rm, even base if possible).
Ensure that the appliance is stable.
Risk of damage to the appliance
Do not lift the pump with the cable or pressure hose as these are not
designed to hold the weight of the pump.
Attention!
To Next Page
Loading...
Need help?
General
