EN
135
CLEANING AND MAINTENANCE
Note:
Before using the pump again, rst “soak” it so that any possible dirt residues do
not block the appliance.
Cleaning and maintenance overview
Cleaning the appliance externally
Rinse with clean water. Remove stubborn contamination with a brush and detergent.
Submerge the pump in a container with clean water and switch on for a short time to rinse
the inside of the pump.
Cleaning the suction area
Clean all accessible parts inside the casing. Remove bres which have wound around the rotor
shaft by opening the pressure connection. Remove stubborn contamination with a brush and
detergent.
Before every use
What? How?
Check casing and cables for damage. Visual inspection.
Check oat switch for damage.
Lift and shake the switch to
check that the metal balls
inside are moving freely.
After every use
What? How?
Clean the appliance.
To Next Page
Loading...
Need help?
General
