EN - 10
4.
IMPORTANT To avoid breaking the starter
cable, do not pull the whole length of it or
let it slide along the edge of the cable guide
hole. Release the starter hand grip gradually,
to prevent it ying back uncontrollably.
IMPORTANT Never wind the
starter cable around your hand.
Never start the chainsaw by holding
on to the starter cable and allowing it
to fall. This is an extremely dangerous
method as you lose complete control
over the machine and the chain.
NOTE The switch is always in
the start position (par. 5.1).
6.3.1 Startup from cold
A "cold " start of the engine means
starting it after at least 5 minutes from when
it was switched off or after refuelling.
1.
2.
3.
NOTE Immediately after the engine
starting, the valve automatically
returns to its original position.
4.
If the machine is not held rmly,
the force of the engine could cause
the user to lose his balance or direct
the bar towards him or an obstacle.
5.
IMPORTANT Do not pull the starter
hand grip more than 4 times.
6.
turning the lever to position «A».
7. Pull the starter grip again until
8.
activate the throttle trigger lever (Fig.
engine to run idle for 10-15 seconds.
9.
IMPORTANT Do not let the engine
run at high speed with the chain brake
engaged, as this could cause overheating
and damage to the clutch.
10. Let the engine run idle for at least 1
IMPORTANT If the starter hand grip is pulled
repeatedly with the choke engaged, it may
ood the engine and make starting dicult. "
If the engine oods (see paragraph 15.5).
6.3.2 Warm start
1.
2.
NOTE Immediately after the engine
starting, the valve automatically
returns to its original position.
3.
4.
6.4 OPERATION
regulations and user instructions
or attached to trestles, in order to
To Next Page
Loading...
Need help?
General
