56
ENGLISH
GB
4 AREAS OF USE
The machine must only be used for cutting grass in
private gardens.
NOTE! This machine is not intended to be driven
on public roads.
5 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed. Risk of
burns and crushing injuries.
5.1Transportation
Never drive the machine off a trailer
with the engine running. Risk of the
machine tipping over and causing ma-
terial damage or fatal injury.
If the machine is transported on a flatbed or trailer,
the machine must be pushed or lifted off/on. The
machine must never be driven off/on with the en-
gine running as driving on slopes requires great
care and the maximum permitted incline can easily
be exceeded. Also see “5.5.2” and “5.5.3”.
5.2 Filling the fuel tank
Always use lead-free petrol. You must never use
2-stroke petrol mixed with oil.
NOTE! Normal unleaded petrol is perishable and
must not be stored longer than 30 days.
Environmental petrol can be used, i.e. alkylate pet-
rol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or top-
ping up. Fill up with fuel before starting
the engine. Never remove the filler cap
or fill with petrol while the engine is
running or still warm.
Fill with petrol as follows:
1. Fold the seat up.
2. Open the fuel cap (6:R).
3. Fill with petrol carefully.
4. Reinstall the fuel cap and fold the seat down.
Never completely fill the petrol tank. Leave an
empty space (= at least the entire filler tube plus 1
- 2 cm at the top of the tank) to allow the petrol to
expand when it warms up without overflowing.
5.3 Level check, engine oil
On delivery, the crankcase is filled with
SAE 10W-30 oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick (7:S).
Unscrew and pull it up.
Wipe the dipstick.
Slide the dipstick down completely and tighten it.
Pull up the dipstick again. Read off the oil level.
Top up with oil to the “FULL” mark (7:T) if the oil
level is below this mark.
The oil level must never exceed the “FULL” mark.
This can cause the engine to overheat. Drain the oil
to the correct level if the oil level exceeds the
“FULL” mark.
5.4 Safety checks
Check that the results of the safety checks below
are met when testing the relevant machine.
The safety checks must always be car-
ried out before use.
If any of the results below are not met,
the machine must not be used. Take the
machine to a service workshop for re-
pair.
5.4.1 General safety checks
5.4.2 Electric safety check
The safety system’s function must al-
ways be checked before use.
Item Result
Fuel lines and con-
nections
No leak.
Power cables All insulation intact.
No mechanical damage.
Exhaust system No leakage in the connec-
tions.
All screws tightened.
Test driving No unusual vibrations.
No unusual noise.
Status Action Result
The clutch-brake pedal
not depressed.
Cutting deck not acti-
vated.
Attempt to
start.
The engine
should not
start.
The clutch-brake pedal
not depressed.
The cutting deck not
activated.
Attempt to
start.
The engine
should not
start.
Engine running.
The cutting deck not
activated.
The opera-
tor leaves
the seat.
The engine
should stop.
Gear engaged Attempt to
start.
The engine
should not
start.
To Next Page
Loading...
Need help?
General
