24EN
6.3.6 Dismantling, replacing and remounting
the blades
WARNING!
Always wear work
gloves when handling the blades.
WARNING!
Damaged or bent
blades must always be replaced; never try
to repair them! ALWAYS USE ORIGINAL
BLADES BEARING THE SYMBOL
!
Only blades with the following codes must be
used on this machine:
82004346/0 (98 cm)
82004357/0 (108 cm)
IMPORTANT
Both of the blades
should be replaced together, especially when
there are slight differences in wear.
The fuse capacity is indicated on the fuse.
IMPORTANT
A blown fuse must al-
ways be replaced by one of the same type and
ampere rating, and never with one of another
rating.
If problems persist, contact Your Dealer.
and provisions for the disposal of oils, petrol,
damaged parts or any elements which have a
strong impact on the environment; this waste
must not be disposed of as normal waste,
it must be separated and taken to specied
waste disposal centres where the material will
be recycled.
– At the time of decommissioning, do not pollute
the environment.
Environmental protection should be a priority of
considerable importance when using the ma-
chine, for the benet of both social coexistence
and the environment in which we live.
– Try not to cause any disturbance to the sur-
rounding area.
– Scrupulously comply with local regulations and
provisions for the disposal of waste materials
after sawing.
– Scrupulously comply with local regulations
7.
ENVIRONMENTAL PROTECTION
1
1
To Next Page
Loading...
Need help?
General
