EN
10 MAINTENANCE AND STORAGE / ACCESSORIES
WARNING! For your safety and that of
others:
– After each use, disconnect the machine
from the mains and check for damage.
– Correct maintenance is essential to main-
tain the original eciency and safety of the
machine over time.
– Keep all nuts, bolts and screws tight to be
sure the equipment is in safe working con-
dition.
– Never use the machine with worn or dam-
aged parts. Damaged parts are to be re-
placed and never repaired.
– Only use original spare parts. Parts that are
not of the same quality can seriously dam-
age the equipment and compromise safety.
WARNING! During maintenance oper-
ations unplug the machine from the mains.
1. MOTOR COOLING
To avoid overheating and damage to the motor,
always keep the cooling air vents clean and free
of sawdust and debris.
2. HEAD COIL REPLACEMENT (Fig. 8)
– Press the two side buttons (1) and remove the
cover (2).
– Lift out the coil (3).
– Reposition the spring (4) and insert the new coil,
making sure that the two ends of the line (5)
protrude from the holes (6) of the head.
– Remount the cover (2).
3. SHARPENING THE LINE CUTTING KNIFE
(Only for SGT 350) (Fig. 9)
– Unscrew the two screws (1) and remove the line
cutting knife (2) from the guard (3).
– Fix the line cutting knife in a vice and sharpen it
using a at le, being careful to retain the origi-
nal cutting angle.
– Ret the knife on the guard.
SGT 600 mod. is provided with a line cutting pin
which does not need sharpening.
4. ELECTRIC CABLES
WARNING! Check the condition of the
electric cables regularly and replace them if
they are worn or their insulation looks dam-
aged.
If the electric cable is damaged, have it replaced
with a genuine spare part by a qualied technician.
5. EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unauthorised
centres or by unqualied persons will totally inval-
idate the warranty.
6. STORAGE
After every work stint, clean the machine thor-
oughly to remove all dust and debris, and repair
or replace any faulty parts.
The machine must be stored in a dry place away
from the elements and out of the reach of children.
The table contains a list of all available accesso-
ries, indicating those which may be used on each
machine, marked with the symbol “ ”.
WARNING! In consideration that the
selection, application and usage of the ac ces
sory to be tted in the variety of possible us-
age are actions made solely by the user, the
latter assumes responsibility for damages of
any kind due to such actions. When in doubt
or if lacking knowledge of the specicity of
each accessory, contact your retailer or spe-
cialised gardening centre.
Code Model: SGT 350 SGT 600
1911-9125-01
1911-9126-01
9. ACCESSORIES
8. MAINTENANCE AND STORAGE
To Next Page
Loading...
Need help?
General
