EN
IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS 3
1) Keep bystanders away.
2) The tool continues to move even after it has
been switched o.
3) Warning! Danger. Failure to use this machine
cor rectly can be hazardous for oneself and
o thers.
4) Disconnect the plug from the mains before
commencing maintenance work or if the power
cord is damaged.
5) Read the instruction manual before using the
machine.
6) Do not leave the machine in the rain (or in
damp conditions).
7) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safetyglas-
ses and hearing protection.
8) Cutting device rotation direction.
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its tted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching o or idle running.
TECHNICAL DATA Model
SGT 350 SGT 600
Power supply voltage V~ 230-240 230
Power supply frequency Hz 50 50
Engine Power W 350 600
Cutting width cm 25 30
Mass Kg 1,9 2,8
No-load Speed min
-1
11.000 11.000
Maximum noise and vibration levels [1] Model
SGT 350 SGT 600
Sound pressure level
– Measurement uncertainty
dB(A)
dB(A)
85,2
1
79,8
1
Measured acoustic power level
– Measurement uncertainty
dB(A)
dB(A)
94,2
0,72
93,5
0,2
Guaranteed
acoustic
power level dB(A) 96 96
Vibration level
– Measurement uncertainty
m/s
2
m/s
2
3,22
1,5
2,35,
1,5
2. SYMBOLS
To Next Page
Loading...
Need help?
General
