EN - 10
6.3.2 Warm start
1. Move the throttle control to
15.C).
2.
15.D).
3. Start
IMPORTANT Do not press
the primer for warm start.
6.3.3 Manual starting
pull
the grip15
Repeat the operation until the engine starts.
NOTE Do not try more than 3/4 times,
otherwise the engine may be ooded.
Check the potential causes of failure to start
in the "Problems identication table".
6.3.4 Electrical starts
Make sure that the power
supply system is equipped with
grounding and protection system.
1. Insert the plug
15
2. Press the start button to start the engine.
3.
6.3.5 Operation
• control, guide the
chute and the de
•
•
•
• Press the auger
• Press the
to engage the traction.
NOTE Always use the engine at full
capacity while using the machine.
6.3.6 Steering
ST 526 S,
ST 625,
ST 665
the desired direction.
the steering is facilitated (see
the technical data table).
ST 665 T,
ST 726 T,
ST 767 H
Press the right or left hand
to turn to the right or to the left.
6.3.7
ST 526 S,
ST 625,
ST 665,
ST 665 T,
ST 726 T
•
•
to the desired position.
•
IMPORTANT Shifting the
gears with the machine running
damages the transmission system.
ST 767 H
•
IMPORTANT Shifting the
gears with the machine at a
standstill may be more dicult.
6.4 STOP
control
• 15.A).
• Move the throttle control
15.C) to stop position.
To Next Page
Loading...
Need help?
General
