To adjust the height of the auger,
•
•
to the position to be set.
•
6. USING THE MACHINE
The safety regulations to
follow while using the machine
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
6.1 PRELIMINARY OPERATIONS
and precautions regarding refuelling and
oil top up (see par. 7.2 and par. 7.3).
to the ground conditions (see par. 4.7).
6.2 SAFETY CHECKS
correspond to those outlined on the tables.
Always carry out the safety
checks before use.
6.2.1
Result
Fuel lines and
connections.
Electrical cables. All insulation intact.
Oil lines
Test driving
6.2.2 Traction and auger operation test
Action Result
Traction operation test
Release the
control
Auger operation test
Press the auger
The auger starts rotating.
Release the auger control. The auger stops
Wheel and auger operation test
control pressed
the auger starts rotating.
Release the auger
auger continues to rotate.
Release
and the auger stops.
If any of the results fail to match
the indications provided in the tables
below, it is not possible to use the
machine! Take it to a service centre to
be checked and repaired if necessary.
6.3
1. Open the fuel tap15.B).
2.
15.A).
6.3.1 Cold start
1. Move the throttle control to
15.C).
2. 15.D).
3. 15
4.
5. 15.D).
IMPORTANT Before operating the machine,
wait for a few minutes for the oil to warm up.
To Next Page
Loading...
Need help?
General
