70
EN
metal or other sharp edged materials.
• Wear the prescribed personal protective
equipment!
CAUTION
The inhalation of dusts can endanger the
health.
• Wear the prescribed personal protective
equipment!
CAUTION
Tipping over of the sliding bracket may lead to
haematomas in users or other persons.
•
sliding bracket cannot tip over.
CAUTION
The agents can contain harmful ingredients
and can thereby cause irritation of the
respiratory tract and the skin.
• Observe the manufacturer's safety data
sheet.
• Avoid spillage and the formation of fog.
•
• Avoid contact with skin and eyes.
metal or other sharp edged materials.
Wear the prescribed personal protective
The inhalation of dusts can endanger the
Wear the prescribed personal protective
Tipping over of the sliding bracket may lead to
haematomas in users or other persons.
sliding bracket cannot tip over.
The agents can contain harmful ingredients
and can thereby cause irritation of the
respiratory tract and the skin.
Observe the manufacturer's safety data
Avoid spillage and the formation of fog.
Avoid contact with skin and eyes.
In the following sections the maintenance and
cleaning work required for optimal and fault-free
operation is described.
in some cases on time and/or load. For the
maintenance interval information shown both in
In case of questions on the maintenance work
and intervals contact the manufacturer.
Maintenance
interval
Maintenance work
Before
starting
work
Check the device to make sure that it
is functioning before starting work. If
necessary, contact the Service.
Check the sliding bracket to make sure that
it is rmly xed in the handle ttings.
Check the sweeping container to make sure
it is rmly xed and in good condition.
Check the plate brooms and the ne dust
sweeping roller for rolled up threads and
cords. Remove these if necessary.
Check the plate brooms and the ne dust
sweeping roller for jammed items or contami-
nation.
Check the handles for contamination and
clean if necessary.
Check that the height adjustment is at the
correct height.
Check the sweeping pressure setting. Adapt
the sweeping pressure to the surface to be
swept, if necessary.
After nishing
work
Empty the sweeping container.
Clean the device.
8 Bh Clean broom drives.
To Next Page
Loading...
Need help?
General
