Stihl 019 T User Manual

STIHL 019 T
40
• Fit pickup body with suction hose in
oil tank opening.
• Tighten down the nut until the oil
pump comes out of the engine
housing.
• Push the thrust piece (1)
1132 893 8700 over the threaded
rod as far as it will go.
• Fit M5 nut.
Removal:
- Remove the oil tank - see 9.2.
• Screw the threaded rod (1)
1132 893 8200 into the oil pump.
- Fit the oil tank in the engine
housing.
- Pull the pickup body out of the oil
tank.
• Press the oil tank against the engine
housing and pull the suction hose
outwards at the same time (this
pulls the taper into the oil tank).
Note: Avoid stretching the suction
hose.
- Place the pickup body in the oil
tank.
- Install the engine - see 4.2.
- Flush out the oil tank.
- Insert pickup body in the suction
hose.
• Push stub (1) into oil pump seat.
Note: The straight face (2) must
engage properly in the engine
housing opening (3).
• Coat taper (4) with a little oil.
9.3 Oil Pum
p

Stihl 019 T Specifications

General

Brand	Stihl
Model	019 T
Category	Chainsaw
Language	English