Stihl E 180 C User Manual

- Remove the chain sprocket
cover - see 4.1.
•
Pull the cover out of the motor
housing.
•
Unscrew the tensioning nut (1)
from the adjusting screw (2).
•
Take the adjusting screw out of
the cover (3).
Install in the reverse sequence.
- Remove the chain sprocket
cover - see 4.1.
•
Take out the complete chain
tensioner.
•
Remove the thrust pad (1).
•
Rotate the spur gear (2) to
unscrew the adjusting screw (3)
fully from the tensioner slide (4).
•
Pull the spur gear (1) out of the
cover (2).
•
Pull off the tensioner slide (1).
•
Take out the adjusting screw (2).
- Inspect the teeth on the spur
gear and adjusting screw,
replace both parts if necessary.
Install in the reverse sequence.
Note: Coat teeth of adjusting
screw and spur gear with
lubricating grease, see 10.2,
before refitting.
7. CHAIN TENSIONER
7.1 Front Chain Tensioner 7.2 Side Chain Tensioner
100RA074
1 4 3 2
VA
100RA076
21
VA
100RA072
VA
100RA073
VA
100RA075
2 1
VA
143RA052
VA
1
2
3
17

Stihl E 180 C Specifications

General

Brand	Stihl
Model	E 180 C
Category	Chainsaw
Language	English