7 Adjusting Trimmer for User
7.1 Fitting and Adjusting the Carry‐
ing System
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand’s
width below your right hip.
7.2 Adjusting the Loop Handle
The loop handle can be set to different positions
to suit the height and reach of the user.
► Shut off the engine.
► Loosen the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check the following points:
–
The spacer sleeve (3) fits between the loop
handle (1) and carrying ring.
–
Distance (a) is no more than 20 cm.
► Tighten down the screws (2) firmly so that the
loop handle cannot be rotated on the drive
tube.
7.3 Balancing the Trimmer
The cutting attachment should rest lightly on the
ground.
► Shut off the engine.
► Connect the carrying ring (2) to the carabi‐
ner (1).
► Wait for trimmer to stop swinging.
► Check position of cutting attachment. If it
needs adjustment:
► Loosen the screw (3).
► Move carrying ring (2) up or down the drive
tube until correct balanced position is reached.
► Tighten down the screw (3) firmly.
8 Mixing Fuel and Refueling
the Brushcutter
8.1 Mixing Fuel
A video is available for this chapter
www.stihl.com/sxpweh
This trimmer requires a fuel mixture of gasoline
and two-stroke engine oil., in a ratio of 50:1.
STIHL recommends you use STIHL MotoMix.
If you mix the fuel yourself, use only STIHL two-
stroke engine oil or another high-performance
engine oil in accordance with JASO FB, JASO
FC, JASO FD, ISO-L-EGB, ISO-L-EGC or ISO-L-
EGD.
STIHL specifies STIHL HP Ultra two-stroke
engine oil or an equivalent high-performance
7 Adjusting Trimmer for User English
0458-500-0121-B 13