Stihl FSE 71 User Manual

17FSE 60, FSE 71, FSE 81
English
Winding Line onto Spool
: Use green-coded nylon line with a
diameter of 2 mm.
: Cut two 2 m lengths of nylon line
from the reel**.
: Rotate the spool (2) counterclock-
wise until the two arrow points are in
alignment.
: Push the straight end of each line
through the sleeves (5) in the
mowing head (3) until you feel
noticeable resistance – and then
continuing pushing as far as stop.
** see “Special Accessories”
: Hold the mowing head steady.
: Rotate the spool counterclockwise
until the shortest line is about 10 cm
long.
: If necessary, cut the longer line to a
length of about 10 cm.
The mowing head is now full.
STIHL AutoCut 5-2
Always inspect the mowing head for
wear before replacing the nylon line.
If there are signs of serious wear,
replace the parts concerned or
install a new mowing head.
Preparations
: Switch off the motor.
: Lay the trimmer on its back with the
mowing head facing up.
Schnur/LINE 2
681BA023 KN
5
Schnur/LINE 1
3
3
2
681BA024 KN
Schnur/LINE 2
Schnur/LINE 1

Stihl FSE 71 Specifications

General

Type	Brush cutter
Head type	Nylon line
Handle type	D-loop handle
Product color	Orange, White
Sound power level	93 dB
Power cable length	0.5 m
Vibration emission	3.3 m/s²
Automatic line feed	Yes
Sound pressure level	82 dB
Cutting diameter (max)	350 mm
Power source	AC
AC input voltage	230 V

Weight and Dimensions

Length	1530 mm
Weight	4000 g