HT 105, HT 134, HT 135
English
29
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
As soon as the engine runs
N Press down the throttle trigger
lockout and open the throttle – the
choke knob moves to the run
position F. After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
Risk of injury from saw chain running
when the engine is idling. Adjust the
carburetor so that the saw chain does
not run when the engine is idling – see
“Adjusting the Carburetor”.
Your machine is now ready for
operation.
Stopping the Engine
N Depress the stop switch – the
engine stops – release the stop
switch – it springs back to the run
position.
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration.
N Move the choke knob to < and
continue cranking until the engine
runs.
Engine does not start in warm start
position <
N Move the choke knob to g and
continue cranking until the engine
runs.
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
Engine is flooded
N Move the choke knob to F and
continue cranking until the engine
runs.
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is already filled with
fuel.
N Set the choke knob to suit the
engine temperature.
N Now start the engine.
0000-GXX-1558-A0
To Next Page
Loading...
Need help?
General
