EasyManuals Logo
Home>Stihl>Chainsaw>MS 192 T

Stihl MS 192 T Manual

Stihl MS 192 T
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
11MS 192 T
4.4 Rewind Starter
Problem Cause Remedy
Starter rope broken Rope pulled out too vigorously as
far as stop or over edge, i.e. not
vertically
Fit new starter rope
Normal wear Fit new starter rope
Starter rope does not rewind Rewind spring broken Replacing the rewind spring
Spring insufficiently tensioned Check rewind spring and increase
tension
Very dirty or corroded Clean or replace rewind spring
Starter rope cannot be pulled out
far enough
Rewind spring overtensioned Check rewind spring and reduce
tension
Starter rope can be pulled out
almost without resistance
(crankshaft does not turn)
Guide peg on pawls or pawls
themselves are worn
Fit new pawls
Spring clip fatigued Fit new spring clip
Starter rope is difficult to pull and
rewinds very slowly
Starter mechanism is very dirty Thoroughly clean complete starter
mechanism

Other manuals for Stihl MS 192 T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl MS 192 T and is the answer not in the manual?

Stihl MS 192 T Specifications

General IconGeneral
BrandStihl
ModelMS 192 T
CategoryChainsaw
LanguageEnglish

Related product manuals