Stihl MS 192 T Manual

6 MS 192 T
3.5 Tightening Torques
DG screws are used in polymer and light metal components. These screws form a permanent thread when they
are installed for the first time. Screws can be removed and installed as often as necessary without impairing the
strength of the screwed assembly, provided that the specified tightening torque is observed.
For this reason, it is essential to use a torque wrench.
Fastener Thread size For component Tightening
torque
Remarks
Nm
Screw DG 4x15 Chain tensioner cover plate / engine
housing
2,5
Screw D 6x13 Collar screw for guide bar, rear 6,0
Collar screw DG 8x18 Collar screw for guide bar, front 16,0
Screw B 4.2x9.5 Cover plate/ screen/ muffler 2,0
Screw P 4x12 Cover/ sprocket cover/ engine housing
tensioner
2,5
Nut M 5 Filter base/ handle housing, 1st stage
aluminium
1,5
Nut M 5 Filter base/ handle housing, 1st stage 2,0
Nut M 5 Filter base/ handle housing, 2nd stage
aluminium
2,5
Nut M 5 Filter base/ handle housing, 2nd stage 3,5
Screw P 6x19 Handle housing/ front handle 6,0
Screw P 4x12 Handle moulding/ handle housing 1,5
Screw P 6x19 Retaining plate/ loop/ engine housing 6,0
Screw DG 5x20 Engine pan/ cylinder 8,0
Screw P 5x16 Bearing plug/ handle housing 4,0
Screw P 5x16 Bearing plug/ engine housing, sprocket
side
4,0
Screw P 5x16 Bearing plug/ engine housing, fan side 4,0
Screw P 5x16 Fan housing/ engine housing 4,0
M 8x1 L Carrier 25,0
Screw DG 5x20Z Engine housing/ cylinder 8,0
Screw DG 4x20 Oil pump/ engine pan 4,5
Screw P 4x12 Annular buffer, support/ engine housing 2,5
Screw P 5x29.6 Annular buffer/ handle housing 5,0
Screw DG 5x20 Muffler / cylinder 9,0
Nut M 8X1 Flywheel/ crankshaft 18,0
M 14x1.25 Spark plug 25,0
Screw DG 4x20 Ignition module/ cylinder 4,5

Stihl MS 192 T Specifications

General

Brand	Stihl
Model	MS 192 T
Category	Chainsaw
Language	English