Stihl MS 193 T User Manual

MS 193 T
English
8
Do not modify the machine in any way –
this may increase the risk of personal
injury –risk of accidents!
To reduce the risk of fire due to ignition
outside the cylinder, move the master
control level to STOP, 0 or † before
turning the engine over on the starter
when the spark plug boot is removed or
the spark plug is unscrewed!
Do not service or store the machine near
a naked flame – risk of fire due to the
fuel.
Check fuel cap regularly for tightness.
Use only spark plugs that are in perfect
condition and have been approved by
STIHL – see "Specifications".
Check ignition lead (insulation in good
condition, secure connection).
Check that the muffler is in perfect
working condition.
Do not use the machine if the muffler is
damaged or missing – risk of fire,
damage to hearing!
Never touch a hot muffler – risk of burns!
The condition of the anti-vibration
elements influences vibration behaviour
– inspect anti-vibration elements
periodically.
Inspect chain catcher – replace if
damaged.
Switch off the engine
– To check the chain tension
– To retension the chain
– To replace the chain
– For remedying malfunctions
Observe sharpening instructions – for
safe and proper handling, always keep
the chain and guide bar in flawless
condition. Keep the chain properly
sharpened, tensioned and well
lubricated.
Change chain, guide bar and chain
sprocket in due time.
Regularly check that the clutch drum is
in perfect working condition.
Always store fuel and chain lubricant
only in the specified type of containers
and ensure they are correctly labelled.
Store in a dry, cool and secure place
protected against light and sunlight.
In the event of a chain brake
malfunction, switch off the machine
immediately – risk of injury! Consult a
servicing dealer – do not use the
machine until the malfunction has been
remedied, see "Chain brake".
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly or if nonapproved replacement
parts were used, STIHL may deny
coverage.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
The most common reactive forces that
occur during cutting are: kickback,
pushback and pull-in.
Dangers of kickback
Kickback occurs when the saw is
suddenly thrown up and back in an
uncontrolled arc towards the operator.
Reactive Forces
Kickback can result in
serious or fatal injury.
0012BA022 KN
H
L

Stihl MS 193 T Specifications

General

Brand	Stihl
Model	MS 193 T
Category	Chainsaw
Language	English