45MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English / USA
If groove depth is less than specified:
: Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
The air filter system can be adapted to
suit different operating conditions by
simply installing a choice of filters.
Fabric filter*
For normal operating conditions and
winter operation.
Fleece filter* (non-woven)
For dry and very dusty work areas.
* see "Guide to Using this Manual"
Dirty air filters reduce engine power,
increase fuel consumption and make
starting more difficult.
If there is a noticeable loss of
engine power
: Press down the throttle trigger
interlock and move the Master
Control lever to l (cold start).
: Turn the twist lock 90° to the left.
: Lift off off the carburetor box cover
vertically.
: Always replace damaged filter
elements.
: Clean away loose dirt from around
the filter.
Chain
type
Pitch Minimum
groove
depth
Picco 3/8“ P 0.20"
(5.0 mm)
Rapid 1/4“ 0.16"
(4.0 mm)
Rapid 3/8“; 0.325“ 0.24"
(6.0 mm)
Rapid 0.404“ 0.28"
(7.0 mm)
Air Filter System
208BA001 KN
Cleaning the Air Filter
208BA005 KN
To Next Page
Loading...
Need help?
General
