Stihl MS 230 User Manual

47MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English / USA
Standard Setting
: Shut off the engine.
: Check the air filter and clean or
replace if necessary.
: Turn high speed screw (H) counter-
clockwise (max.
3
/
4
turn) as far as
stop.
: Carefully screw the low speed
screw (L) down onto its seat
(clockwise), then turn it one full
turn counterclockwise from that
position.
Adjusting Idle Speed
Engine stops while idling
: Carefully screw the low speed
screw (L) down onto its seat
(clockwise), then turn it one full
turn counterclockwise from that
position.
: Turn the idle speed screw (LA)
slowly clockwise until the chain
begins to run – then turn the screw
back one quarter of a turn from
that position.
Chain runs while engine is idling
: Carefully screw the low speed
screw (L) down onto its seat
(clockwise), then turn it one full
turn counterclockwise from that
position.
: Turn the idle speed screw (LA)
slowly counterclockwise until the
chain stops running – then turn the
screw another quarter of a turn in
the same direction.
Erratic idling behavior, poor
acceleration
(even though L screw is open 1 full turn)
Idle setting is too lean:
: Turn low speed screw (L)
counterclockwise until the engine
runs and accelerates smoothly.
It is usually necessary to change the
setting of the idle speed screw (LA)
after every correction to the low speed
screw (L).
L
H
/
3
4
1
208BA006 KN
H
L
L
H
/
3
4
1
208BA007 KN
H
LA
L

Stihl MS 230 Specifications

General

Brand	Stihl
Model	MS 230
Category	Chainsaw
Language	English