Stihl MS 441 C-M User Manual

MS 441 C-M
English
42
N Turn the guide bar over – every time
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar groove
(3).
N Measure the groove depth – with the
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
If groove depth is less than specified:
N Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
The air filter system can be adapted to
different operating conditions by the
insertion of different air filters.
Retrofitting is simple.
N HD2-Filter (black filter frame. folded
filter fabric) Universal filter for
almost all conditions of use (from
very dusty to wintry conditions etc.)
N Wire mesh filter (green filter
housing) Use in extra-ordinary
conditions e.g. extremely wintry
conditions of use - such as powder
snow or drift snow. Rather
unsuitable in very dusty conditions.
When dry, STIHL filters attain a long
service life.
N Always use STIHL filters dry
Taking Care of the Guide Bar
Chain
type
Chain pitch Minimum
groove depth
Picco 1/4" P 0.16" (4.0 mm)
Rapid 1/4" 0.16" (4.0 mm)
2
3
1
143BA026 KN
Picco 3/8" P 0.20" (5.0 mm)
Rapid 3/8"; 0.325" 0.24" (6.0 mm)
Rapid 0.404" 0.28" (7.0 mm)
Air Filter System
001BA210 KN
001BA212 KN

Stihl MS 441 C-M Specifications

General

Motor type	2-stroke motor
Chain gauge	1.3 mm
Chain pitch	3/8 \
Automatic oiling	Yes
Oil tank capacity	0.36 L
Fuel tank capacity	0.725 L
Engine displacement	70.7 cm³
Engine power	5.6 hp
Power source	Gasoline

Weight and Dimensions

Weight	6600 g