0458-663-0121-A
18
English
8 Connecting to a water source
► Unscrew connector (1).
► Screw water filter (2) onto the water supply and tighten by
hand.
► Screw connector (1) onto water filter (2) and tighten by
hand.
Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2”.
– The water hose is between 10 m and 25 m long.
► Connect water hose to a water tap.
► Turn on the water tap fully and rinse the water hose with
water.
Sand and dirt will be rinsed out of the water hose. The
water hose will be vented.
► Turn off water tap.
► Push the coupling (1) onto the connector (2).
The coupling (1) audibly engages.
► Open water tap fully.
► If the spray lance is fitted to the spray gun: Remove spray
lance.
► Keep the trigger of the spray gun pressed until an even jet
of water is delivered by the spray gun.
► Release spray gun trigger.
► Lock spray gun trigger.
► Fit spray lance.
► Attach the nozzle.
Removing the water hose
► Turn off water tap.
► To release the coupling: Pull or turn ring (1) and hold.
► Pull the coupling off the connector (2).
8.2 Connecting the pressure washer to another
water supply
The pressure washer can draw in water from water butts,
cisterns and flowing or still rivers and lakes.
2 1
0000-GXX-9845-A0
2 1
0000-GXX-9855-A0
To Next Page
Loading...
Need help?
General
