EN
59
0478 131 8354 D - EN
crosses one of these guide loops during
the drive home. It then travels to the
perimeter wire and on to the docking
station.
Guide loops with an external docking
station:
To the right and left of the access to the
external docking station, two guide
loops (1) have to be installed at an angle of
90° to the perimeter wire.
Minimum clearance to access: 2m
Guide loops with corridors:
To the right and left of the corridor access,
two guide loops (1) have to be installed at
an angle of 90° to the perimeter wire.
These must always be located in the part
of the mowing area that can only be
accessed via a corridor.
Minimum clearance to corridor access:
2m
Installation of a guide loop:
Guide loops must not be installed in the
vicinity of corners.
Minimum clearance to corners: 2m
Install the guide loop in the mowing area
as shown. The perimeter wire (1) must be
fastened to the ground with two fixing pins
at the edge A and must not be crossed.
Minimum length: 100 cm
Wire routing pin to pin B.
● Attach the guide loop to the ground with
a sufficient number of fixing pins.
12.13 Accurate mowing along edges
Minimum width of edging stones:
Route the perimeter wire at a clearance of
33 cm to the obstacle. To ensure that the
lawn edge is mown completely, the edging
stones must have a width of at least
26 cm. If wider edging stones are laid, the
lawn edge is cut even more precisely.
If several consecutive corridors are
installed, guide loops must be
installed in each of the relevant
mowing areas.
A strip with a width of up to 26 cm is
left unmown along high obstacles. If
necessary, edging stones can be
laid around high obstacles.
To Next Page
Loading...
Need help?
General
