■
Pull the starter handle slowly, until
resistance is felt.
This is the "compression" point.
Return the handle to its original
position and pull swiftly.
■
Do not pull out the rope all the way.
■
After starting the engine, allow the
starter handle to return to its origi-
nal position while still holding the
handle.
RECOIL STARTER
STARTING
1
■
Set the throttle lever to the idling
position.
■
If the stop switch is installed on the
engine.Set the stop switch to the
position "ON or I ".
■
If the stop switch is installed on a
machine side.Set the stop switch to
the position "ON or I ".
Close the choke lever.
■
If the engine is cold or the ambient
temperature is low, close the
choke
lever
fully.
■
If the engine is warm or the ambient
temperature is high, open the
choke lever half-way, or keep it
fully open.
STOP SWITCH
CHOKE LEVER
2