96
10.) Slave 3 must remain on “0” position
11.) On the right side at the bottom the red LED light is illuminated for 10 seconds; wait.
12.) After 10 seconds the LED light will be turned off and configurated automatically as Slave 1.
13.) Wait until SLAVE1 commences operation (venting flow has to start opposed to MASTER on
automatic mode)
14.) As soon as Slave1 is operating, continue with the connection to Slave2 (repeat steps 8 to 10)
5.1 RESET ADVANCED
ATTENTION If the product is not set up properly (MASTER or SLAVE), it is possible to use the RESET
function to restore the product to its default conditions - this process is explained in the remote
controller manual.
1.) Set switch on the edge to “0”, wait for 5 seconds and then turn it on “1”.
2.) The red LED light will be illuminated for 10 seconds. Within this period press _______ button
5 times. Red LED light will remain illuminated.
3.) Turn off the device and set switch back on “0”. It has been reset successfully. Follow steps
described in chapter 5.0 to reconfigure the units.
If LED light is turned off after 10 seconds (see item 2), restart again.
5.2 CONFIGURATION PRODUCTS ASTER SLAVE –WIRELESS
Chapter 3.7. describes electric connection for device´s power supply. NOTE: Each device must only
be switched on if the previous device has commenced operation. To avoid communication
problems between different devices, which are not part of the same system, it is necessary to set
up an explicit codification, so the devices will communicate only with each other and not with
neighboring systems.
Adhere to the following instruction for correct configuration (Example: 3 units connected to
master-slave.)
1.) Switch on WIRELESS (MASTER) on the left edge. The switch on 3 more units has to be set on
“0”.
2.) Red and white LED lights start to flash alternately. This shows that the device is waiting for
the 8-digit code to identify the system of devices. Please write down the key sequence,
written down in the chart on the next page, as it has to be used for all devices´ configuration.
3.) Enter 8-digit code using the following buttons:
In this phase all other buttons will be deactivated. If pressed, they won´t give an acoustic signal.
Adhere to the following instruction for correct configuration (Example: 3 units connected to
master-slave.)
To Next Page
Loading...
Need help?
General
