7-50
INSPECTION AND MAINTENANCE
68PM2-01E
Bulb replacement
Headlights
Discharge headlights
Since special procedures are required, we
recommend you take your vehicle to your
SUZUKI dealer for bulb replacement.
Halogen headlights
68PM00714
(1) Headlight (high/low beam)
68PM00715
Open the engine food. Disconnect the cou-
pler (2). Remove the sealing rubber (3).
Push the retaining spring (4) forward and
unhook it. Then remove the bulb. Install a
new bulb in the reverse order of removal.
CAUTION
• Light bulbs can be hot enough to
burn your finger right after turning
off lights. This is true especially for
halogen headlight bulbs. Replace
the bulbs after they become cool
enough.
• The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit
or dropped. Handle them carefully.
• To avoid injury by sharp-edged
parts of the body, wear gloves and
a long-sleeved shirt when replacing
light bulbs.
NOTICE
The oils from your skin may cause a
halogen bulb to overheat and burst
when the lights are on. Grasp a new
bulb with a clean cloth.
NOTICE
Frequent bulb replacement indicates
the need for an inspection of the elec-
trical system. This should be carried
out by your SUZUKI dealer.
WARNING
Never attempt to replace the bulb of a
discharge headlight, or you could
suffer an electric shock from the
high-voltage circuit in the headlight
system. Always have a discharge
headlight bulb replaced by an autho-
rized SUZUKI dealer.
(1)
To Next Page
Loading...
Need help?
General
