25
DIAGNOSTIC SYSTEM
If abnormal conditions exist in any sensor sig-
nal being input to the control unit, the self-diag-
nostic system warns of the abnormal condition.
TILLER HANDLE MODEL
If this system activates, the caution lamp will
flash.
Also incorporated is a fail-safe provision that
allows the operation at a restricted speed even
under such a failure condition.
The failed system can be identified by the mode
of the caution lamp flashing.
The diagnostic code is designed to appear
when the engine is running.
REMOTE CONTROL MODEL
If this system activates, the caution lamp will
flash and a buzzer will sound.
Also incorporated is a fail-safe provision that
allows the operation at a restricted speed even
under such a failure condition.
The failed system can be identified by the mode
of the caution lamp flashing and buzzer sound-
ing.
This diagnostic code is designed to appear
while the ignition key is turned on.
The buzzer sound with diagnostic system acti-
vating will be stopped after approx. thirty sec-
onds.
NOTICE
If the diagnostic system activates while you
are operating your outboard motor, there is an
abnormal condition in one of the sensor sig-
nals of the control system.
Consult your authorized Suzuki marine dealer
for repair of the control system.
OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)
SYSTEM ACTIVATION
TILLER HANDLE MODEL
When the total operating hours have reached
the preprogrammed hours, the caution lamp will
flash while the engine is running. This indication
will repeat until you cancel the system activa-
tion.
REMOTE CONTROL MODEL
When the total operating hours have reached
the preprogrammed hours, the caution lamp will
flash. This indication will repeat until you cancel
the system activation.
CANCELLATION
TILLER HANDLE MODEL
1. Start the motor.
Make sure that the motor is in “NEUTRAL”
and the throttle grip is fully closed.
NOTE:
The engine stops when the engine stop button
is kept to push more than 0.5 seconds.
To Next Page
Loading...
Need help?
General
