10
NOTE:
• If equipped with Keyless Start System:
Set the Keyless Start System to the OFF
state before connecting or disconnecting the
rotation select connector.
• If not equipped with Keyless Start System:
Turn the ignition key OFF before connecting
or disconnecting the rotation select connec-
tor.
BATTERY INSTALLATION
BATTERY REQUIREMENTS
Do not use deep cycle batteries and gel-cell
batteries for starting engines.
Use a 12 Volt starting-type lead acid battery
that meets the specifications shown below.
1000 Marine Cranking Amps (MCA)/ABYC,
or 800 Cold Cranking Amps (CCA)/SAE
or 180 Reserve Capacity (RC) Minutes/SAE
or 12 Volt, 130 AH
NOTE:
• The specifications listed above are the mini-
mum battery rating requirements for starting
the engine.
• When connecting batteries in parallel, they
must be of the same type, capacity, manufac-
turer, and of similar age. When replacement
is necessary, they should be replaced as a
set. Consult your Suzuki dealer for proper
battery installation information.
• If your boat application requires additional
battery loads, it is recommended that an aux-
iliary battery or batteries be installed. Consult
your Suzuki dealer for proper battery installa-
tion information.
To Next Page
Loading...
Need help?
General
