47
REMOTE CONTROL MODEL
If it is necessary to remove the outboard motor
from your boat, we recommend that you ask
your authorized Suzuki Marine Dealer to do the
work for you.
MOTOR TRANSPORTING
When transporting the motor, place the motor
either vertically or horizontally.
Vertical transport:
Attach the motor to the carrier by securing
clamp bracket with two clamp screws.
Never use display stand for transportation of the
motor.
Horizontal transport:
1. Drain the gasoline from the engine fuel line.
Refer to the MOTOR REMOVAL section.
2. Raise the tiller handle and rest the motor on
a case protector with the port side down-
wards as shown.
WARNING
Spilled fuel or fuel vapor can cause a fire and
is hazardous to health.
Always take the following precautions:
• Drain the fuel from the fuel line and fuel
vapor separator before transporting the
boat/outboard motor and before removing
the motor from the boat.
• DO NOT lay motor on its side without drain-
ing fuel.
• Keep the motor away from open flames or
sparks.
• Wipe up spilled fuel immediately.
NOTICE
If you do not take proper precautions when
transporting your outboard, it can be dam-
aged.
• Do not rest the engine in any of the posi-
tions shown below, as water and oil may
enter the cylinder through the exhaust port
or the outer casings may be damaged.
• Do not place the engine on its side before
the cooling water has drained from it com-
pletely, as water may enter the cylinder
through the exhaust port and cause prob-
lems.
INCORRECT
To Next Page
Loading...
Need help?
General
