0A-6 General Information:
Vehicle Lifting Points
S6JB0A0101005
WARNING
!
• Before applying hoist to underbody, always take vehicle balance throughout service into
consideration. Vehicle balance on hoist may change depending of what part to be removed.
• Before lifting up the vehicle, check to be sure that end of hoist arm is not in contact with brake pipe,
fuel pipe, bracket or any other part.
• When using frame contact hoist, apply hoist as shown (right and left at the same position). Lift up
the vehicle till 4 tires are a little off the ground and make sure that the vehicle will not fall off by
trying to move vehicle body in both ways. Work can be started only after this confirmation.
• Make absolutely sure to lock hoist after vehicle is hoisted up.
: 1
: 3: 2
4
I5JB0A010002-02
1. Support position for frame contact hoist (when engine assembly is not removed) and safety stand 3. Floor jack position
2. Support position for frame contact hoist (when engine assembly is removed) 4. Vehicle front
To Next Page
Loading...
Need help?
General
