2-16
Front Brake Lever Adjustment
The distance between the throttle grip
and the front brake lever is adjustable
to 5 positions. To change the position,
push the brake lever forward and turn
the adjuster to the desired position.
When changing the brake lever posi-
tion, always be sure the adjuster
stops in the proper position; a projec-
tion of the brake lever pivot should fit
into the depression of the adjuster.
This motorcycle is delivered from the
factory with its adjuster set on posi-
tion 3.
ELECTRIC STARTER SWITCH “.”
3
This switch is used for operating the
starter motor. With the ignition switch
in the “ON” position, the engine stop
switch in “$”, the transmission in
neutral, squeeze the clutch lever,
push the electric starter switch to
operate the starter motor and start
the engine.
NOTE: This motorcycle is equipped
with interlock switches for the ignition
circuit and the starter circuit. The
engine can only be started if:
• The transmission is in neutral and
the clutch is disengaged, or
• The transmission is in gear, the
side stand is fully up and the
clutch is disengaged.
WARNING
Adjusting the front brake lever
position while riding can be haz-
ardous. Removing a hand from the
handlebars can reduce your ability
to control the motorcycle.
Never adjust the front brake lever
position while riding. Keep both
hands on the handlebars.
To Next Page
Loading...
Need help?
General
