91
4
4-1. Speech command system operation
Speech command system
COROLLA_HV(TMUK)_OEM_MM_(EE)
directly into the microphone
when giving a command.
●
Speech commands may not be recog-
nized if:
• Spoken too quickly.
• Spoken at a low or high volume.
• The windows are open.
• Passengers are talking while speech
commands are spoken.
• The fan speed of the air conditioning
system is set at high.
• The air conditioning vents are turned
towards the microphone.
●
In the following conditions, the system
may not recognize the command
properly and using speech commands
may not be possible:
• The command is incorrect or unclear.
Note that certain words, accents or
speech patterns may be difficult for
the system to recognize.
• There is excessive background noise,
such as wind noise.
●
Wait for the confirmation beep before
speaking a command.
●
This system may not operate immedi-
ately after the power switch is in ACC
or ON.
1 Press the talk switch.
The speech command system is
activated.
Pressing the talk switch while a
voice prompt is playing, will stop
the voice recognition prompt and
immediately play the start listen-
ing tone.
While in voice recognition mode,
pressing and holding the talk
switch for 1 or more seconds
cancels voice recognition mode.
2 After a beep sounds, say the
desired command or select the
desired command.
■
Displaying the command list
screen
1 Say “More commands” or select
“More commands” on the
speech command main menu
screen.
2 Say the desired command or
select the desired command.
●
The command list is read out and the
corresponding command is high-
lighted. To cancel this function, press
the talk switch.
Speech command system
operation
To Next Page
Loading...
Need help?
General