7-58
INSPECTION AND MAINTENANCE
(For K15C engine model)
74SB20706
1) Unclamp the side and center clamps
and remove the element from the air
cleaner case. If it appears to be dirty,
replace it with a new one.
2) Clamp the side and center clamps
securely.
Spark plugs
Spark plug replacement and inspec-
tion
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to a SUZUKI dealer.
80JM125
To access the spark plug:
1) Remove the air cleaner case. Refer to
“Air cleaner” in this section.
2) Disconnect the negative cable of the
battery. Refer to “Battery” in this sec-
tion.
3) If necessary, disconnect the coupler (1)
while pushing the release lever.
4) Remove the bolts.
5) Pull out the ignition coils straight.
NOTE:
During installation, check that the wires,
couplers, sealing rubber of air cleaner
chassis and washers, are correctly
returned in place.
78K179
(1)
NOTICE
• When pulling out the ignition coils,
do not pull on the cable. Pulling on
the cable can damage it.
• When servicing the iridium/plati-
num spark plugs (slender center
electrode type plugs), do not touch
the center electrode, as it is easy to
be damaged.
To Next Page
Loading...
Need help?
General
