Suzuki VL800 User Manual

7-27
To add specified engine coolant:
1. Place the motorcycle on the
side stand.
2. Remove the bolts 1 and cover
2.
3. Remove the filler cap and add
specified engine coolant
through the filler hole.
NOTE: Adding only water will
dilute the engine coolant and
reduce its effectiveness. Add
specified engine coolant.
Radiator Hose Inspection
Inspect the radiator hoses for
cracks, damage or engine coolant
leakage. If any defects are found,
ask your Suzuki dealer to replace
the radiator hose with a new one.
 WARNING
Engine coolant is harmful or
fatal if swallowed or inhaled.
Solution can be poisonous to
animals.
Do not drink antifreeze or cool-
ant solution. If swallowed, do
not induce vomiting. Immedi-
ately contact a poison control
center or a physician. Avoid
inhaling mist or hot vapors; if
inhaled, remove to fresh air. If
coolant gets in eyes, flush eyes
with water and seek medical
attention. Wash thoroughly
after handling. Keep out of the
reach of children and animals.

Suzuki VL800 Specifications

General

Engine Type	4-stroke, liquid-cooled, SOHC, 45-degree V-twin
Displacement	805 cc
Bore x Stroke	83.0 mm x 74.4 mm
Compression Ratio	9.4:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Disc brake
Rear Brakes	Drum brake
Wheelbase	1, 655 mm (65.2 in)
Ground Clearance	140 mm (5.5 in)
Seat Height	700 mm (27.6 in)
Front Tire	130/90-16M/C 67H
Rear Tire	170/80-15M/C 77H
Overall Height	1, 110 mm (43.7 in)