Sym Fiddle II 50 SYM Series User Manual

SYM 6. CYLINDER HEAD/VALVE
6-13
CYLINDER HEAD INSTALLATION
Install the lock pins and new cylinder head
gasket onto the cylinder head.
Install the camshaft chain plate.
Install the cylinder head.
CAMSHAFT INSTALLATION
Assemble the camshaft holder.
Install the exhaust valve rocker arm set onto
the camshaft holder showing “EX” mark.
Install intake valve rocker arm and rocker
arm shaft.
Caution
With T type wrench to turn crankshaft in a
clockwise motion so that the “T” mark on the
flywheel aligns with the mark on crankcase.
(piston is at TDC position)
Place the TDC marks of the cam sprocket at
same level of the top-end of cylinder head.
The other single hole of the cam sprocket is
in upward. Then, install the cam chain onto
the cam sprocket.
The tangent of rocker shaft of intake
valve should match with the bolt hole of
camshaft mounting seat.
Lock pins
Cylinder head gasket
Chain plate
5mm blot
Rocker
arm shaft
Rocker arm
Camshaft
Cam chain

Sym Fiddle II 50 SYM Series Specifications

General

Brand	Sym
Model	Fiddle II 50 SYM Series
Category	Motorcycle
Language	English